Frameless VB36 with drawers

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Gene Davis

Frameless VB36 with drawers

Post by Gene Davis »

We want to stick with frameless, but need a design for a little 36-wide one-sink vanity. The competition is a cheap thing from KraftMaid.

The pic, done in Sketchup because it still is faster for me to use than eCabs, shows the concept.

Can anyone suggest something simpler and better?
Attachments
Frameless VB36 with drawers.jpg
Frameless VB36 with drawers.jpg (214.12 KiB) Viewed 3973 times
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Post by Brian Shannon »

This is a faceframe cab I just finished today. It may give you ideas. The top drawer front is false or tilt-out. I built this with no bottom rail then attached a skirt to the bottom drawer front that allowed me to put a deep drawer at the bottom. The customer saw this design at H.D. but the quality sucked.

Brian
Attachments
Std Base Framed.jpg
Std Base Framed.jpg (19.78 KiB) Viewed 3980 times
Std Base Framed.hsf
(1.16 MiB) Downloaded 312 times
Gene Davis

Post by Gene Davis »

Thanks, Brian, but frameless is the keyword.
Jerry McClain
Junior Member
Posts: 42
Joined: Fri, May 25 2007, 8:55AM

offset vanity

Post by Jerry McClain »

Here is one I have used. It is for an offset bowl application.
Attachments
VSB36 offset bowl.jpg
VSB36 offset bowl.jpg (18.79 KiB) Viewed 3938 times
JLM
Post Reply