I have been experiencing some problems when cutting melamine panels. I am using a 1/2\" compressing spiral and while the cutter is ramping the up-cut on the bit is chipping the melamine.
I was wondering what everyone else was doing about this. I thought about not ramping and just plunging into the cut, could someone tell me what the setting should be in rolling nest to stop the ramping or any other suggestions that help.
Thanks
MELAMINE AND RAMPING
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 171
- Joined: Tue, Jun 21 2005, 3:23PM
- Location: Connellsville, PA
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- Senior Member
- Posts: 171
- Joined: Tue, Jun 21 2005, 3:23PM
- Location: Connellsville, PA
I am not sure what brand of compression bit I am using at the moment, but I don't think its a mortise and tenon compression. Someone else did tell me to try those, what is the difference?
The upcut on the bit I am using presently is 1/2\", so should I change the preramp depth to 1/2\" or is that to much.
Thanks again for the help!
The upcut on the bit I am using presently is 1/2\", so should I change the preramp depth to 1/2\" or is that to much.
Thanks again for the help!
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact: