These Sharps are nice, but pricey.
I thought you might like to see how one looks done in a frameless arrangement. The cab housing it is a faceframed box with depth 3/4 less than the drawerstack box underneath. The cutout in the back is per Sharp's spec, and is for the wall receptacle.
Sorry about the quality of the photos, as they were taken with my phone.
Built-in Sharp undercounter MW
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
Built-in Sharp undercounter MW
- Attachments
-
- SharpMWcabAssy.jpg (29.59 KiB) Viewed 5293 times
-
- 227439721_760583642_0.jpg (24.91 KiB) Viewed 5315 times
-
- 227439665_760583444_0.jpg (23 KiB) Viewed 5314 times
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Built-in Sharp undercounter MW
Nice job and your phone pics look good to
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- eCabinets Beta Tester
- Posts: 1740
- Joined: Tue, May 17 2005, 8:33PM
- Company Name: Timeless Cabinetry and Mantles
- Location: South East
Re: Built-in Sharp undercounter MW
How much overhang did the microwave have over the frame?
What was the opening and frame size?
What was the opening and frame size?
Intel Core i7-5820K (6-Cores, 3.3GHz, 15MB Cache)
32Gigs DDR4
NVIDIA GeForce GTX 960 4GB
SSD 840 256Gig, 2TB, 3TB, Samsung (2TB)
Corsair RM650
32Gigs DDR4
NVIDIA GeForce GTX 960 4GB
SSD 840 256Gig, 2TB, 3TB, Samsung (2TB)
Corsair RM650
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
Re: Built-in Sharp undercounter MW
Here's one that I did.
- Attachments
-
- sharp microwave drawer.pdf
- (360.68 KiB) Downloaded 339 times
-
- Junior Member
- Posts: 70
- Joined: Mon, Nov 28 2005, 10:12PM
- Location: LUBBOCK, TX
Re: Built-in Sharp undercounter MW
I have been using this appliance very regularly and when I perform a part editor cut on the back, it yanks a couple of my dados out of the cabinet.
I've had to resort to manual labor for my part editor cuts.
I've had to resort to manual labor for my part editor cuts.