door question?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 68
- Joined: Fri, Jun 23 2006, 9:01AM
- Location: palm harbor, fl
door question?
i'm trying to do a rout in my doors. the question is how do you do it, and gt it a nest. i'm using slab doors.
Re: door question?
Darren
Slab doors can be taken in to the part editor to apply any machine operations you are wanting on the door.
Slab doors can be taken in to the part editor to apply any machine operations you are wanting on the door.
-
- Wizard Member
- Posts: 4723
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: door question?
Darren,
I have always used the MDF door selection (with whatever material I really want to use) if I am doing part editor edge cuts because I haven't found a way to remove the edge banding where it doesn't show. I created an edgebanding called NONE with a 0" width and 0" thickness but it still shows after you run an edge profile using a slab door.
Kerry
I have always used the MDF door selection (with whatever material I really want to use) if I am doing part editor edge cuts because I haven't found a way to remove the edge banding where it doesn't show. I created an edgebanding called NONE with a 0" width and 0" thickness but it still shows after you run an edge profile using a slab door.
Kerry