Profile Edge

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

leigh mills
Senior Member
Posts: 211
Joined: Wed, Jan 23 2008, 9:49AM
Location: England UK
Contact:

Profile Edge

Postby leigh mills » Mon, May 19 2008, 8:17AM

Hi guys,

I have a question about the profile edge. with the profile edge tool I understand that the line leading to the red dot indercates the way the cut will perform but where will the cut start? Is this illustrated by the red dot? Also can you change where the cut will start?

Thanks

Leigh

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests