5.2 Crashing

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

DarrelMWood
Junior Member
Posts: 52
Joined: Mon, May 22 2006, 2:02PM
Location: Chicago IL
Contact:

Re: 5.2 Crashing

Post by DarrelMWood »

I was having problems with freezing/crashing. I ended up working in 5.1, but it still had problems with running out of memory. I think I just had two much detail going on (I had it set to the lowest settings in ecabs for everything)---it was a kitchen with essentially two rooms of cabinets, crowns, lots of walls, lighting, a big island with turned posts, etc. I also got a lot of HOOPS errors, which meant I was running out of usable memory.
I ended up deleting one "room" of cabs and doing it was two separate job files. I then had essentially no problems. So now I'm back to using 5.2 instead of 5.1 and I am ever so happy. I had only worked in 5.2 for a couple days, but it was tough to go back to 5.1----I found the usability in 5.2 so much better and more intuitive.
Post Reply