Hello everyone, I am new to ecabinets but I am finding that it works very well
and the interface the the router is magic.
I out source my doors and I am looking for a way to have a report that will act as a
door order list. The only place I can find door information is on the cut list.
I can't find a way to export that information and or creat my own report.
Can some one point out how this can be done?
I am also unable to get hinge holes to work on a 45deg angle upper corner cabinet.
I assigned a 45deg hinge with a hole pattern and it shows up on the door but not the
cabinet gable itself.
Thanks in advance for any help
Spruce Grove, Alberta
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests