RN manual

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

RN manual

Post by Jeff Norris »

is there any additional imformation on the layers for RN since pocketing operations were enabled? the one i have is from 3.85
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Post by Paul Ford »

Hi Jeff,
Aparently Ryan is working on an updated manual as we speak. I have asked for them to post it on here when it is finished which was going to be yesterday afternoon. Hopefully tomorrow it might be here.
I have a manual for V4.74 attached. I haven't had a chance to read it yet so you can have a look through it and see if it is of assistance to you.
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

thanks paul
Post Reply