Triangular Cabinet & Line Drawing Editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Rachelle DeShields
New Member
Posts: 8
Joined: Tue, May 16 2006, 11:55AM
Location: Glencoe, OK

Triangular Cabinet & Line Drawing Editor

Postby Rachelle DeShields » Thu, Aug 21 2008, 8:55AM

I am trying to design a triangular corner cabinet but the "corner cabinet" won't let me set it the way I need it (with no left and right depths). Also, I've been having trouble with Line Drawing Editor since I installed build 2 of 5.2. It won't recognize or highlight some of the cabinets in an assembly to insert measurements. Anyone have any suggestions. Thanks :)

Todd Miller

Re: Triangular Cabinet & Line Drawing Editor

Postby Todd Miller » Thu, Aug 21 2008, 2:52PM

Rachelle DeShields wrote:I am trying to design a triangular corner cabinet but the "corner cabinet" won't let me set it the way I need it (with no left and right depths). Also, I've been having trouble with Line Drawing Editor since I installed build 2 of 5.2. It won't recognize or highlight some of the cabinets in an assembly to insert measurements. Anyone have any suggestions. Thanks :)



Rachelle,

First open a corner cabinet
Next, go into Construction settings and remove the left and right endpanels.
Then, set the Depth right Depth to .76 (If your material thickness is .75)
Finally, set the depth left depth to .76 (same as above)

NOTE: make sure you have the corner gap set to zero.

I have attached the file. HTH

I'll see what I can do about the LDE issue...
Attachments
corner cab1.hsf
(138.02 KiB) Downloaded 82 times


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 11 guests