Carving
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
Carving
Has anyone tried the carving program yet?
-
- eCabinets Beta Tester
- Posts: 386
- Joined: Tue, May 10 2005, 5:23AM
- Location: Lancaster, NH
- Contact:
I have run some a test pieces and a couple of paying jobs through the carving program, it is impressive. Basically, you load your part on the machine, set your center point for the carving position and go to work. We carved a few items in a mantle for one customer and made a dozen rosettes in Santos Mahogany for another customer. The carving program is a great way to offer complete control over material type and carving position. Another really cool feature is the ability to scale the part. You don't have to cut the carving at the size it was created, you can scale it up or down ( I think the limitation is 40% to 200% of original size). Thus far my customers have been very pleased with the results.
Bill R
Bill R
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
I have ordered some of the bits from Thermwood. I am also set up with an account for the carving but just haven't had time to play yet. I'm glad to hear from someone that has used the program. I am also looking forward to the Custom Moulding program for crown and other trims that WE design. I spoke to Eric about a release date and he said it is very close to being ready. They will send an email announcement in a week or two detailing how to download an install packet.
Brian
Brian
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA