Hello All
I outsource my drawer boxes, but place them so the cnc can bore the holes for the slides.
In the same way that my outsourced doors dont show on the cut list, is there something similar for the drawer boxes?
Thanks
Steve
Dont want drawerboxes in the cutlist
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 31
- Joined: Mon, Aug 04 2008, 1:07PM
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Re: Dont want drawerboxes in the cutlist
Steve,
you do not have to place drawer boxes for the CNC to bore the holes for the slides. You can set up so the holes get bored with the drawer front. Drawer front and doors can be made out of material that's differnt from the cabinet so they can be easily filtered out from the nest.
Nemanja
you do not have to place drawer boxes for the CNC to bore the holes for the slides. You can set up so the holes get bored with the drawer front. Drawer front and doors can be made out of material that's differnt from the cabinet so they can be easily filtered out from the nest.
Nemanja
-
- Junior Member
- Posts: 31
- Joined: Mon, Aug 04 2008, 1:07PM
Re: Dont want drawerboxes in the cutlist
Thanks Nemanja
Where would associate the holes to the drawer front?
The Hardware Hole Editor?
Steve
Where would associate the holes to the drawer front?
The Hardware Hole Editor?
Steve
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Re: Dont want drawerboxes in the cutlist
Steve,
go to door/Drawer Editor and go to Hardware Selection. Pick the slide that you need and associate a hole pattern. After you do that, click on Set as Default Drawer (not Drawer Box) and you are set.
Nemanja
go to door/Drawer Editor and go to Hardware Selection. Pick the slide that you need and associate a hole pattern. After you do that, click on Set as Default Drawer (not Drawer Box) and you are set.
Nemanja
-
- Junior Member
- Posts: 31
- Joined: Mon, Aug 04 2008, 1:07PM
Re: Dont want drawerboxes in the cutlist
Thanks Nemanja
I always wondered what that was for
Steve
I always wondered what that was for
Steve