Grass Zargen Drawer Slide Hole Patterns

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Jon Kenworthy
Junior Member
Posts: 43
Joined: Thu, Mar 27 2008, 6:00PM
Company Name: darrells Carpenter Shop
Location: Marana, AZ

Grass Zargen Drawer Slide Hole Patterns

Post by Jon Kenworthy »

Does anyone understand the numbering in the Hardware Hole Editor Standard Patterns for the Grass Zargen Drawer Slides? The 4 5/8" height to the 8 3/8" height have corresponding numbers in the Standard Patterns (22700 - 22911) then it jumps up to 30926 and higher. I am guessing these must be for the 1 11/16" height and the 3 3/8" height but I can't figure it out.
Michael S Murray
eCabinets Beta Tester
Posts: 933
Joined: Tue, May 17 2005, 2:48PM
Location: Logansport, In
Contact:

Re: Grass Zargen Drawer Slide Hole Patterns

Post by Michael S Murray »

Hi Jon,
I never whipped the software where Zargens are concerned. What I ended up doing was building a library of the different configurations I needed and used the part editor to place the holes I needed. If you follow grass kiss system it actually will begin to make since after a while. What I do is keep all the different size sides I need with the line drilling holes, and then I choose the holes I need for whatever cabinet config. and then put those holes only in the actual cabinet. Simple way for simple mind!!!
Mike Murray
Versatile Cabinet & Solid Surface
mike@versatilecabinet.com
http://www.versatilecabinet.com
Jon Kenworthy
Junior Member
Posts: 43
Joined: Thu, Mar 27 2008, 6:00PM
Company Name: darrells Carpenter Shop
Location: Marana, AZ

Re: Grass Zargen Drawer Slide Hole Patterns

Post by Jon Kenworthy »

Thanks, Mike. Simple is good.
Jon
Post Reply