Printing in V6.2

[Cy Rebarchak]

Hi All,
I'm trying to print a line drawing of a very simple cabinet in V6 build 2. I keep getting the error below and Ecab closes without printing. This just started happening with build 2. Any ideas? I've attached the job file also.
Thanks,
Cy

Error Message:
AppName: ecabinets.exe AppVer: 6.0.34.0 ModName: hoops_mvo1713_vc80.dll
ModVer: 17.13.2.0 Offset: 001132a4

[Gary Puckett]

Cy,

I just tried your cabinet and it printed out just fine on my system

Gary

[FredHirsch]

Cy,
What is your printer make model and do you know the driver version?
Fred

[Cy Rebarchak]

Fred,
I am using a HP Officejet J6480. The driver ?? I tried printing to a .pdf and it was only successful 2 out of 6 tries. Ecab would shut down. It's only a problem when printing from the line drawing editor. The cabinet prints fine from the cab. editor.
Cy

[Terry Davis]

Same problem here, "ecabinet systems application has encountered a problem and needs to close" happens everytime i try to print. (HP Officejet pro K5400)

[Jason Fabretti]

Same here, Mine just crashes and locks up...

[Jon Dieterlen]

I changed the print quality to draft in the printer properties. Then open the window showing the print job progress and wait until it is completely done printing the page before attempting to print another page.

A little slow, but it has worked for me.

Jon

[Terry Davis]

Does not matter what I set the properties to or what printer in the shop I send it to it will crash, any ideas I really need to print out drawings.