Measure tool error?

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Terry Davis
Senior Member
Posts: 179
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Measure tool error?

Post by Terry Davis »

When I use "Maintenance Tool Unload" to return a bit to the typewriter head to take out a dull bit and use "Maintenance Tool Load to return a new bit to the spindle I'm getting an error when I go to measure that bit. It says " Invalid AFL statement, maybe files may be open" I read it twice to make sure I was reading it right! Then I have to exit Supercontrol and restart it then I can measure the bit as usual without the error.
Carl Jones
Thermwood Team
Posts: 46
Joined: Fri, Mar 16 2007, 7:46AM

Re: Measure tool error?

Post by Carl Jones »

Hello Terry, What version of THM software is on your control currently? Try pressing "Ctrl" and "V", it should pop up on the screen. Thanks
Thermwood Technician
Terry Davis
Senior Member
Posts: 179
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Re: Measure tool error?

Post by Terry Davis »

Carl,
ver 7.4.5.10 installed about 2 months ago.
Carl Jones
Thermwood Team
Posts: 46
Joined: Fri, Mar 16 2007, 7:46AM

Re: Measure tool error?

Post by Carl Jones »

Thanks Terry, I will get back to you asap on this.
Thermwood Technician
Carl Jones
Thermwood Team
Posts: 46
Joined: Fri, Mar 16 2007, 7:46AM

Re: Measure tool error?

Post by Carl Jones »

Hello Terry, what is a good number that I can reach you? I will call you. Thanks
Thermwood Technician
Terry Davis
Senior Member
Posts: 179
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Re: Measure tool error?

Post by Terry Davis »

Hi Carl,
(724) 925-9100
Post Reply