Question about mdf doors using custom cutters

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Scott Marshburn
Guru Member
Posts: 837
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:
Contact Scott Marshburn

Question about mdf doors using custom cutters

Post by Scott Marshburn »

Has anyone tried using pockets created in ecabinets to cut mdf doors with 3 cutters?
Top
Forrest Chapman
eCabinets Beta Tester
Posts: 1236
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:
Contact Forrest Chapman

Re: Question about mdf doors using custom cutters

Post by Forrest Chapman »

Can you explain how that might work?

Forrest
Top
Forrest Chapman
eCabinets Beta Tester
Posts: 1236
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:
Contact Forrest Chapman

Re: Question about mdf doors using custom cutters

Post by Forrest Chapman »

Strike that I found the discussion on the machine forum.
Top
Scott Marshburn
Guru Member
Posts: 837
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:
Contact Scott Marshburn

Re: Question about mdf doors using custom cutters

Post by Scott Marshburn »

Forrest,
Do you think this would work in ecab? We have not had a chance to try it this past week but plan too some time next week.
Top
Post Reply

Return to “eCabinet Systems Software”