I just cut a job where I added pilot holes for screws via the Part Editor. They were 1/8" diameter through cuts.
When I ran the job the holes were not drilled completely through the material. My shelf pin holes on partitions which are through cuts fell short as well.
The code written for both was correct, the thickness of material plus the cut through depth amount but they still didn't drill through.
Is this a material thickness setting problem? Did these cuts not go through because they are considered pocket cuts and not actual through cuts?
I am just looking for some ideas on what I did wrong.
The pilot holes are going to be great when I get them right. As it was I still had to drill them all by hand.