Corner Cab Bug
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 477
- Joined: Tue, May 17 2005, 1:55PM
Corner Cab Bug
Here is a cabinet that I changed the corner settings on and it shows the change but when I take the top to PE it still shows a mitered corner and I cannot do what I wanted to do -- 7.5" x 7.5" corner cutout.
-
- Wizard Member
- Posts: 4723
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Corner Cab Bug
Wally,
Your cabinet seems to work as it should.
Are you talking about the miter on the front of the cabinet or the back?
Your cabinet seems to work as it should.
Are you talking about the miter on the front of the cabinet or the back?
-
- Guru Member
- Posts: 477
- Joined: Tue, May 17 2005, 1:55PM
Re: Corner Cab Bug
At the back Kerry-- I don't want any miter there but it keeps it even when I change it. I want a square of 7.5" cut from the corner (to go around a post) not a miter.
-
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: Corner Cab Bug
Hi Wally
Is this what you are looking for
Is this what you are looking for
- Attachments
-
- Corner Cab_11-25-11.hsf
- (808.02 KiB) Downloaded 353 times
-
- Wizard Member
- Posts: 4723
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Corner Cab Bug
Wally,
Your cabinet works fine for me.
Try opening the cabinet in the cab editor then right click and choose Remove Part Editor Cuts/From Entire Cabinet and let the cabinet re-generate and see if you can get it to work in the part editor.
Your cabinet works fine for me.
Try opening the cabinet in the cab editor then right click and choose Remove Part Editor Cuts/From Entire Cabinet and let the cabinet re-generate and see if you can get it to work in the part editor.
-
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: Corner Cab Bug
Here is one for you Kerry
I will have to try that
I will have to try that
- Attachments
-
- Corner Cab with Pipes_11-27-11.esa
- (908.02 KiB) Downloaded 381 times
-
- Guru Member
- Posts: 477
- Joined: Tue, May 17 2005, 1:55PM
Re: Corner Cab Bug
That's it George -- I guess I will have to regenerate it like Kerry advises to get it right.George Davidson wrote:Hi Wally
Is this what you are looking for
Thanks George.
-
- Guru Member
- Posts: 477
- Joined: Tue, May 17 2005, 1:55PM
Re: Corner Cab Bug
Thanks Kerry - I must have lingering PE cuts.Kerry Fullington wrote:Wally,
Your cabinet works fine for me.
Try opening the cabinet in the cab editor then right click and choose Remove Part Editor Cuts/From Entire Cabinet and let the cabinet re-generate and see if you can get it to work in the part editor.