hey All,
i need to make a small TV cabinet left end is at a 45* angle. I see the angle part button for the horizontal parts but how would I get the left end to move to the 45*?? so that the shelf, deck and top will follow.
Thanks,
Chris
Angled Cabinet
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 113
- Joined: Fri, Jul 29 2005, 4:00PM
- Location: Helendale, CA.
Re: Angled Cabinet
Chris,
Do a search on this forum for Angled Cabinet. Kerry Fullerton has posted a couple of examples.
Also you could use a standard base cabinet, just elimnate one of the ends and then chop off the deck, top and any shelves in the Part Editor.
Dennis
Do a search on this forum for Angled Cabinet. Kerry Fullerton has posted a couple of examples.
Also you could use a standard base cabinet, just elimnate one of the ends and then chop off the deck, top and any shelves in the Part Editor.
Dennis
-
- Senior Member
- Posts: 113
- Joined: Fri, Jul 29 2005, 4:00PM
- Location: Helendale, CA.
Re: Angled Cabinet
Thanx Dennis that is what I did... Just thought there was a way to do this easy-like.
Chris
Chris