Reception Desk

Brian Shannon · Post by **Brian Shannon** » Sun, Apr 22 2012, 10:09PM

Just finished this Bamboo reception desk! All parts were cut on the Thermwood. Curves were made from stacked archs, not bent. Lots of time! Finally done!

Brian Shannon · Post by **Brian Shannon** » Sun, Apr 22 2012, 10:22PM

More pictures

George Davidson · Post by **George Davidson** » Mon, Apr 23 2012, 11:05AM

Very nice Brian

Brad McIntosh · Post by **Brad McIntosh** » Thu, Apr 26 2012, 8:31AM

Very nice work there!

Interestingly enough, C&D have a manufacturing facility up here in Canada located no more than 30-45 minutes away from us. They have a 5 axis Model 70 as well as a couple of CS45s.

Brian Shannon · Post by **Brian Shannon** » Thu, Apr 26 2012, 10:12AM

Thanks Guys. I thought it was strange that they didn't make it themselves as they have several Thermwood routers at this location. C and D has expanded to double its capacity in the past 8-9 months! I think they usually cut large aluminum molds for plastic injection. This was a very cool project but a whole lot of work!

Brian

Dave White · Post by **Dave White** » Wed, May 02 2012, 3:05PM

Hey Brian,
Good seeing you again the other day! I was at C&D again on Monday and made a point to check out the desk. Told the receptionist I was the QC dept for the Thermwood owners at large user group and needed to inspect your handi-work, which I did. Needless to say you passed with flying colors and I reported back to my superiors at the user group (they're a sly bunch as I've never met them in person.....) an A+ for your creation, which I believe entitles you to a free cheeseburger at McDonalds. The receptionist loved it as well which should get you a free drink with the cheeseburger. Good job!!

Dave White · Post by **Dave White** » Wed, May 02 2012, 3:09PM

All kidding aside, it's a very beautiful and stunning piece. Fantastic work.

Brian Shannon · Post by **Brian Shannon** » Wed, May 02 2012, 3:20PM

Thanks Dave! It was good to visit with you too. Can I get fries with that?

Brian

Dave White · Post by **Dave White** » Wed, May 02 2012, 3:32PM

If you sing the Tim McGraw song by the same name I'll make sure you get fries and make it a Double Cheeseburger!

Mark McCallum · Post by **Mark McCallum** » Wed, May 16 2012, 8:00PM

Absolutely Beautiful work.
I hope that bench top stays stable.

John Powell · Post by **John Powell** » Sat, May 19 2012, 10:55PM

Great work Brian.
Can you tell me did you veneer directly onto the mdf stacked arches, what was the process after gluing up,
What thickness do the doors end up, what was the thickness of the mdf used for the arches, is the dowel 8mm? This process would save me having to make formers for every
different radius needed.
Thanks John.

Thermwood / eCabinet Systems

Reception Desk

Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk

Re: Reception Desk