Anyone ever get this warning

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Anyone ever get this warning

Post by Chris B Campbell »

Trying to run a simple box get this warning while nesting in C.N. Did a dry run everything seems fine but...
Any help??
Thanks,
Chris
Attachments
screen shot.jpg
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Anyone ever get this warning

Post by Scott G Vaal »

Chris B Campbell wrote:Trying to run a simple box get this warning while nesting in C.N. Did a dry run everything seems fine but...
Any help?? Well I see the bmp extension is not allowed ... Warning states: Appropriate start point for outline operation 4 on "left End" not found.
Thanks,
Chris
Chris,

We will need more info. Please attach or send us an export from CN with the twd loaded that causes the error. Also, send us the job, cab, or assm that you created the twd from.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Anyone ever get this warning

Post by Scott G Vaal »

Chris,

I cannot reproduce the issue here. You did not get me an actual export, so I do not have your exact settings. I would recommend that you first update to the newest version of Control Nesting and then try it again. If it still gives you the error, then get me an actual export and I will try it here. Thanks in advance.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Post Reply