Problem... I am trying to cut out several sheets which have drill operations, pockets and of course an outline. On the drill operations it is specified to use the 1/4 comp. tool, but for some reason it wants to drill the holes with the 1/4 comp, then use the 1/8 straight to clean up the hole,which changes the diameter and renders the piece useless. I changed the clean up to 0 and then 4-5 holes later it tries to use the 1/8 straight again. In the DXF there are 2 different diameter holes to be drilled. One is .28 and the other is approximately 1 inch. In my tool settings I do not have the 1/8 straight selected for drill operations, only the pocket is selected, why would the program be wanting to use 1/8" straight to drill a 1" diamet hole. Now I could eliminate the 1/8, except I need it in use to pocket the text that are being cut to .0625. Any suggestions?? I mean basically right now my questions are:
1) In the DXF the layer for holes that need to be cut is labeled drill, but on the super controller it is showing pocket/rout, why?
2) Does the program always want to clean up the holes in a drill operation?