drawer box front for pull-outs

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: drawer box front for pull-outs

Post by Chris B Campbell »

Done
Joe Harger

Re: drawer box front for pull-outs

Post by Joe Harger »

Hello, I am going to ask you to send cab file to program@thermwood.com as well....Until I get that, can you change the diameter of that tool being used by just a little bit to see what happens..? Do you know the radius of the arc you made? What size diameter of bit? I have seen before where a certain diameter of bit has caused those circles to show up on screen and error out when running but changing the diameter of the bit by a fraction eliminates it..

Joe Harger
Software Support
Thermwood Corporation
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: drawer box front for pull-outs

Post by Chris B Campbell »

Hi Joe,

I can try the bit dia. size soon, right now it is set at .235 with time left. as far as the arc dia. It's a 3 point arc. Radius of the arc... Well regrettably the line drawing editor doesn't recognize a drawer box to pull measurements off of.

Chris
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: drawer box front for pull-outs

Post by Chris B Campbell »

Changed tool dia. to .25" Same problem.

Chris
Joe Harger

Re: drawer box front for pull-outs

Post by Joe Harger »

Hello, it looks like in settings the run arcs tab is causing the situation...uncheck this tab and see if it just pockets that area instead of following the circle around the part. We are doing some further studying of your file to make sure it isnt the way part was created that is causing the problem. I did a quick test creating drawer box and seem to be finding the same thing....uncheck this for now and let me know if it fixed it....

runars.png

Joe Harger
Software Support
Thermwood Corporation
Rick Deskins
Thermwood Team
Posts: 857
Joined: Tue, May 17 2005, 12:47PM
Company Name: Thermwood
Country: UNITED STATES
Location: Thermwood

Re: drawer box front for pull-outs

Post by Rick Deskins »

This looks to be a eCabinets bug. The arc should be part of the outline, however when the cnc is being generated by ecabinets it is not being include in the outline and is made into a route. I will put this on the list to be fixed. In the mean time, hopefully Joe's suggestion will get you through until the bug is fixed.
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: drawer box front for pull-outs

Post by Chris B Campbell »

Seems to nest ok. I will run it later today. Don't understand why this changed? I am not sure if this was checked in the past??

Thanks,
Chris
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: drawer box front for pull-outs

Post by Chris B Campbell »

didn't see the last post.....
Thanks again,
Chris
Post Reply