CN Optimization

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

CN Optimization

Post by Georgi Baltov »

I think it'll be nice if the CN could be optimized for speed a bit. Same way eCabinets is after adding a bunch of new features. Sometimes the amount of time it needs to lead is ridiculous. And that is from the main window clicking on the CN button. Inside CN going to the cabinet part list might be even longer.
jason galbraith
Senior Member
Posts: 249
Joined: Wed, Dec 10 2008, 3:29PM
Company Name: Eastcoast Ultimate
Country: AUSTRALIA
Contact:

Re: CN Optimization

Post by jason galbraith »

Try increasing the amount of RAM on your controller. You could also get the the new Q-core controller, our nest times are really quick now.
Core i7-2600 @ 3.70Ghz - 8 GB ram - Win 7 Ultimate 64bit - 2 x 24" ASUS monitors - Nvidia 600 Quadro 1GB graphics
www.eastcoastultimate.com.au
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

Re: CN Optimization

Post by Georgi Baltov »

What did the upgrade cost you?
jason galbraith
Senior Member
Posts: 249
Joined: Wed, Dec 10 2008, 3:29PM
Company Name: Eastcoast Ultimate
Country: AUSTRALIA
Contact:

Re: CN Optimization

Post by jason galbraith »

Roughly 17K for the upgrade. Take about 5K off of that being in the US. RAM is definitely cheaper :) Also you could check your Motherboard specs and see if you can upgrade the processor. Those two items will be considerably cheaper and should see you get performance increases.
Core i7-2600 @ 3.70Ghz - 8 GB ram - Win 7 Ultimate 64bit - 2 x 24" ASUS monitors - Nvidia 600 Quadro 1GB graphics
www.eastcoastultimate.com.au
Post Reply