Flycutting Program

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
John Tortorello
New Member
Posts: 11
Joined: Fri, Dec 30 2005, 8:40AM
Company Name: Commercial Millwork Inc
Location: 221 west division streetSyracuse,NY
Contact:

Flycutting Program

Post by John Tortorello »

I had a strange thing happen yesterday,
After running parts yesterday, I decided to flycut the waste board, when I loaded the program I noticed that It had been over written with the last program I ran (see attached).
Can anybody explain to me what happened?
Can someone send me a copy so I can replace it?

John
Attachments
THM_Flycut.NC MSM.txt
(7.39 KiB) Downloaded 428 times
Joe Harger

Re: Flycutting Program

Post by Joe Harger »

I have talked to and sent new Flycut program



Joe Harger
Software Support
Post Reply