batch lists not saving
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 60
- Joined: Mon, Mar 26 2012, 10:40PM
- Company Name: cutshop
- Country: NEW ZEALAND
batch lists not saving
Hi i just downloaded build 9 and i created a list of panels in the batch (cabinets with only the side remaining, i do this so i can display taping instructions on stickers) i saved it but when i went open it it just sent me back to the main page?
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: batch lists not saving
I am not able to reproduce this. Here is what I tried:Alex Bowler wrote:Hi i just downloaded build 9 and i created a list of panels in the batch (cabinets with only the side remaining, i do this so i can display taping instructions on stickers) i saved it but when i went open it it just sent me back to the main page?
1.) I created a cabinet that is only a right end with edge banding
2.) Added 8 different sizes to a batch list
3.) Saved the job
4.) reloaded the job
If you repeat your steps will it happen again? If so, I may need your cabinet and the steps you take.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000