Is there anyway to make a cabinet like this by entering the dimensions as opposed to adding and angling parts on an assembly.
Place to discuss only the "Design Sharing" aspects of the eCabinet Systems software.
2 posts • Page 1 of 1
- Guru Member
- Posts: 755
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
Carl you would probably get more responses if you posted this in the eCabinets Software Forum. As For that type of cabinet The only way that I am aware of is to cut the angles on the parts in part editor and add a face frame from another cabinet and save it as a assembly
Yes! Oh Yes! I Think We Are Going to make It!
Who is online
Users browsing this forum: No registered users and 0 guests