Flip Parts in CN 5.74

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

Flip Parts in CN 5.74

Post by Georgi Baltov »

I am getting flip operations on a G2S parts that only have machining operations on one side. Is anyone else getting the same thing. The issue started with CN 5.74. The same cabinet was run on 5.73 with no issue. I've attached it to the post. The pocket on the drawer fronts are machined as flip.
Attachments
U03 B 76x 17x 36 7-8.zip
(802.5 KiB) Downloaded 412 times
Daniel Vonderheide
Thermwood Team
Posts: 361
Joined: Wed, May 17 2006, 11:25AM
Location: Thermwood

Re: Flip Parts in CN 5.74

Post by Daniel Vonderheide »

Georgi,

You have the two lower drawer slabs in a group with the upper drawer front. This upper drawer front has drill holes on the back side of it. Because they are grouped and there is machining on both sides of the parts in the group, Control Nesting is setting the pockets as the flip operation instead of the drill holes. If you ungroup the parts, they nest without any flip operation.
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

Re: Flip Parts in CN 5.74

Post by Georgi Baltov »

Can I delete my post? Haha. :oops:

Daniel, sorry for wasting your time.
Post Reply