Flip Parts in CN 5.74

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

Flip Parts in CN 5.74

Postby Georgi Baltov » Wed, Apr 10 2013, 4:03PM

I am getting flip operations on a G2S parts that only have machining operations on one side. Is anyone else getting the same thing. The issue started with CN 5.74. The same cabinet was run on 5.73 with no issue. I've attached it to the post. The pocket on the drawer fronts are machined as flip.
Attachments
U03 B 76x 17x 36 7-8.zip
(802.5 KiB) Downloaded 104 times

Daniel Vonderheide
Thermwood Team
Posts: 358
Joined: Wed, May 17 2006, 11:25AM
Location: Thermwood

Re: Flip Parts in CN 5.74

Postby Daniel Vonderheide » Thu, Apr 11 2013, 8:01AM

Georgi,

You have the two lower drawer slabs in a group with the upper drawer front. This upper drawer front has drill holes on the back side of it. Because they are grouped and there is machining on both sides of the parts in the group, Control Nesting is setting the pockets as the flip operation instead of the drill holes. If you ungroup the parts, they nest without any flip operation.

User avatar
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

Re: Flip Parts in CN 5.74

Postby Georgi Baltov » Thu, Apr 11 2013, 3:08PM

Can I delete my post? Haha. :oops:

Daniel, sorry for wasting your time.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 4 guests