Grain Direction

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Chris B Campbell
Senior Member
Posts: 113
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Grain Direction

Post by Chris B Campbell »

hey All,

Is it possible to change the grain direction of a face frame made of sheet stock?? I want my rails to have vertical grain.

Thanks,
Chris
Wally Schneeberger
Guru Member
Posts: 477
Joined: Tue, May 17 2005, 1:55PM

Re: Grain Direction

Post by Wally Schneeberger »

Try switching your height and width measurements.

Forget it it doesn't work !! Maybe add an image with the grain going the other way and create a new sheet stock with that image.
Dennis Englert

Re: Grain Direction

Post by Dennis Englert »

There isn't a way to toggle the grain direction. Changing your jpg image would not rotate the grain if you are cutting the part only the image.

Dennis
Post Reply