Re: spoil switch and M999, how to access...

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Steve Dyches
Junior Member
Posts: 82
Joined: Wed, May 24 2006, 1:52PM
Location: Beech Island, SC
Contact:

Re: spoil switch and M999, how to access...

Post by Steve Dyches »

Re: spoil switch and M999

I'm getting back into the daily oversight of our Thermwood router and need a little help.

I need to adjust the setting for the spoil switch and it looks like the manual is telling me to access the M999 macro by opening the tool measure dialog and then hit cancel.
But when I do that it zooms through a bunch of code in the blink of an eye and ends with a few lines of code that do not include M999.

How do I get into the M999 code to adjust the setting?

Thanks

Steve
Thanks,

Steve Dyches
http://www.frostkeading.com
Daniel Odom
Senior Member
Posts: 204
Joined: Thu, Oct 20 2011, 12:52PM
Company Name: Carlton Kitchen and Bath
Country: UNITED STATES

Re: spoil switch and M999, how to access...

Post by Daniel Odom »

Do a file search on the computer for m999, you should find a text file. If you find it you can open it with notepad and edit it and save. You can even create a shortcut to it and pin it to the task bar so it's easy to access.
Steve Dyches
Junior Member
Posts: 82
Joined: Wed, May 24 2006, 1:52PM
Location: Beech Island, SC
Contact:

Re: spoil switch and M999, how to access...

Post by Steve Dyches »

Thanks! That was easy.
Thanks,

Steve Dyches
http://www.frostkeading.com
Post Reply