Print off fall labels only in 5.78 ?

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Scott Marshburn
Guru Member
Posts: 736
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Print off fall labels only in 5.78 ?

Postby Scott Marshburn » Wed, Mar 05 2014, 2:24PM

Just Upgraded Control nesting 5.78. I went to print the labels. It printed all of the labels for each part. Before we were able to print just the barcode labels for the off fall only. Could any one tell me witch file to select . To Print off fall labels only?
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips

User avatar
Brad McIntosh
Guru Member
Posts: 480
Joined: Wed, May 18 2005, 6:59PM
Company Name: CNC Automation
Location: St. Zotique, Québec, Canada
Contact:

Re: Print off fall labels only in 5.78 ?

Postby Brad McIntosh » Wed, Mar 05 2014, 5:13PM

Not sure there was an official label for "Off Falls Only" from Thermwood.

You may want to check the thread here...

viewtopic.php?f=3&t=9472&p=52601&hilit=off+fall+label#p52601

Scott Marshburn
Guru Member
Posts: 736
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: Print off fall labels only in 5.78 ?

Postby Scott Marshburn » Wed, Mar 05 2014, 6:38PM

Hi Brad. Thanks For your reply
I am not Shure of that also but I do know that as of yesterday and before, we could print labels that had barcodes only and these were off falls. The file that we have ben using is address labels barcode or something like that. My apologies but I am at home so I cannot give the exact file that we had set. I will check it out in the morning and post the file. The point that I am trying to get at is. Was the file settings that we had set prior to the up grade reset to some sort of default or did the Barcode label files change altogether? I do not know but what I do know is that before the upgrade we could print address labels with barcode and only the off fall labels would print. Now when we print the labels all parts are printed only with a barcode beneath them.
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests