Offfall nesting corner not obeying

Jeremy Schiffer · Post by **Jeremy Schiffer** » Mon, Apr 28 2014, 10:36AM

Using CN 5.78, the nesting position for offfalls (lower left, upper right, etc.) is not obeying the setting. It is always nests in the upper right. I don't see anyone else complaining about this, so I wonder if it is somehow specific to my machine. I just updated to 5.78, so I'm guessing it is something to do with that. Is there a settings file I could delete that will get it cleared up perhaps? Anyone had the same problem?

Jeremy Schiffer · Post by **Jeremy Schiffer** » Mon, Apr 28 2014, 11:00AM

Solved... I had to check "ignore settings grouping"... now all I gotta do is figure out what that is and how to use it.

Thermwood / eCabinet Systems

Offfall nesting corner not obeying

Offfall nesting corner not obeying

Re: Offfall nesting corner not obeying