Recently we've been noticing that when we try to cut a 4inch arc using a *.dxf in the control nesting, it seems to cut the in-ramp corner straight into our piece then follow the correct arc and then it finishes again notched inside the arc!!!! checked the dxf and there is nothing out of the ordinary! I lowered the ramp to 0.001 since it did not allow me to erase it completely and it still notches the arc but does not create long ramp (of course)!
Please help!
Kovi
Arc Dxf Ramp Error
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 24
- Joined: Fri, Dec 14 2012, 10:08AM
- Company Name: Aspec
- Country: CANADA
- Location: St-Odilon
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Arc Dxf Ramp Error
Stephane,
Can you send us a copy of your DXF so that we can take a look at it? / Pouvez-vous nous envoyer une copie de votre DXF afin que nous puissions le vérifier?
Hopefully we can assist you. / J'espère que nous pourrons vous aider.
Can you send us a copy of your DXF so that we can take a look at it? / Pouvez-vous nous envoyer une copie de votre DXF afin que nous puissions le vérifier?
- ----------------------------------------------------------------------------------------
Questions de «support au logiciel»??
Envoyez-nous un courriel à logiciel@cncautomation.com
ou
Appelez-nous @ 1-800-421-5955 et demandez à
parler avec un représentant de support au logiciel.
----------------------------------------------------------------------------------------
Software Support Questions??
Email us at software@cncautomation.com
or
Call us @ 1-800-421-5955 and ask to speak
with a software support representative.
----------------------------------------------------------------------------------------
Hopefully we can assist you. / J'espère que nous pourrons vous aider.
-
- New Member
- Posts: 24
- Joined: Fri, Dec 14 2012, 10:08AM
- Company Name: Aspec
- Country: CANADA
- Location: St-Odilon
Re: Arc Dxf Ramp Error
I'll try to clarify my problem! The problem is when we use the control nest to nest dxfs that are in an arc form. the outline ramp-in doesn't realise that it is an arc and therefore cuts straight the length of the in-ramp and then follows my arc. This has been happening only since the latest update!!! I now have to manually nest them and create a custom cutting program for each nest!! not very efficient Also while nesting it is doing a horrible job of it! Chec This Photo of a nest!!
Any ideas????
Kovi
Any ideas????
Kovi