I've done everything the same per the training instructions etc and get the hole patterns the way I want them for everything. The drawer slides and door hinge mount show up perfectly but the door hinge hole (35mm hole) pattern does not show up? The slides, hinges, and mounts all show with the correct number up in the buy list. Whats going on? Any help appreciated..... very frustrated to say the least!
Thanks
Ted
Door Hardware hole Pattern
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 13
- Joined: Tue, May 12 2009, 9:45AM
- Company Name: Vanity Fair Custom Cabinetry
Re: Door Hardware hole Pattern
Please find attached the cabinet in question. Hope this is the correct file? This same problem is happening to all cabinets. Hope you can lend some assistance. Thanking you in advance
Ted Illi
- Attachments
-
- 60 Vanity Ft.hsf
- (2.04 MiB) Downloaded 321 times
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Door Hardware hole Pattern
Ted,
I believe Dennis had wanted you to email the cabinet to the support group. Hopefully someone there will review this thread and see your attachment.
I believe Dennis had wanted you to email the cabinet to the support group. Hopefully someone there will review this thread and see your attachment.
Re: Door Hardware hole Pattern
Saw the post this morning.
While the doors are designated as Build in House, these are 5 piece doors will not show the hole pattern. It does not cut these doors on the machine. If you replace the doors with a slab door, you will see a pattern.
Dennis
While the doors are designated as Build in House, these are 5 piece doors will not show the hole pattern. It does not cut these doors on the machine. If you replace the doors with a slab door, you will see a pattern.
Dennis
-
- New Member
- Posts: 13
- Joined: Tue, May 12 2009, 9:45AM
- Company Name: Vanity Fair Custom Cabinetry
Re: Door Hardware hole Pattern
Thanks much to all. I now understand why the holes don't show up or get drilled. However the holes still need to be drilled? Also now know why in house 5 piece flat panel doors made with sheet stock don't get nested or cut either. Is a separate door program for building in house doors required? Wondering what others do to run in house doors components?
Ted
Ted