Would anyone be able to remind me if there is a way to change the width of the angled (center) back of the 90 degree corner cab? If it can be eliminated at all?
Thanks,
Tim
Width of angled back on corner cab
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Width of angled back on corner cab
Tim,
This is controlled by the Corner Gap setting on the Corner Settings tab of construction settings. If you make it a larger value, the center back will get wider. If you set this to zero (0), it will remove it all together. Hope this helps.
This is controlled by the Corner Gap setting on the Corner Settings tab of construction settings. If you make it a larger value, the center back will get wider. If you set this to zero (0), it will remove it all together. Hope this helps.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Re: Width of angled back on corner cab
Thanks Scott!
Re: Width of angled back on corner cab
Also, the width of the center back is double the corner gap.
Dennis
Dennis