Blum TandemBox slide including the 10mm front fixing holes

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Neville Bastian
Guru Member
Posts: 622
Joined: Fri, May 20 2005, 6:48PM
Company Name: Classic Cabinetry
Location: Albany Western Australia
Contact:

Blum TandemBox slide including the 10mm front fixing holes

Postby Neville Bastian » Tue, Feb 03 2015, 7:38PM

Hi Everyone,
I am just changing from Hettich drawers to Blum and was wondering if someone is willing to send there drilling patterns for Blum TandemBox slide including the 10mm front fixing holes.
It would be good to have a system that has been fine tuned on actual cabinets. We do the euro / frameless cabinets but I am not sure that matters compared to framed?
If you could email them to neville at classiccabinetry dot biz or post them here as a reply for future users searches that would be greatly apprecated.
Regards


Neville
Neville Australia

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Bing [Bot] and 7 guests