Would it be possible too
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 837
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Would it be possible too
Allow to use the pocket hole feature with blind and full dadoes. We dado our face frames into our ends. If I use the lock dado w/Pocket Screw I cannot set the top and bottom insets to 0 and offset the pocket screw also. If I set the top and bottom inset to say 3 inches then the ends will be notched out by this amount, leaving a void. I know that this would be no problem for the base cabinets or the tops of the uppers but the bottoms would not go over well. In the mage below I have the top and bottom inset set to 0 inches.
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
-
- Guru Member
- Posts: 837
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Re: Would it be possible too
Ok so I did not upload the image. Here it is
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467