Doors to part editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
JR Allen
Junior Member
Posts: 84
Joined: Sun, Mar 16 2014, 1:48PM
Company Name: JRs Woodworx
Country: UNITED STATES

Doors to part editor

Post by JR Allen »

Hello all, Seeking some advice on how to place a trash hole cutout in a door panel. I've selected a door and exported but can not take to part editor to cut a hole. Been a while since I subscribed to the video area and not sure if the answer is there. Thanks in advance for any info.
Scott Marshburn
Guru Member
Posts: 837
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: Doors to part editor

Post by Scott Marshburn »

Hi Jr.
The only doors that are supported in the part editor Are slab doors. If you are using a slab door then you can select it and then take it into the Part editor. Here you can create the geometry for the cutout. Then create a pocket.
JR Allen
Junior Member
Posts: 84
Joined: Sun, Mar 16 2014, 1:48PM
Company Name: JRs Woodworx
Country: UNITED STATES

Re: Doors to part editor

Post by JR Allen »

Thanks Scott, need to do this in a raised panel just didn't want to try and recreate the RP & stile profile in a slab door.
Post Reply