Discuss Thermwood 3-axis Machinery, Controller, and Software.
3 posts • Page 1 of 1
- eCabinets Beta Tester
- Posts: 1126
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
I think that control nest is not compensating properly for the amount it trims off the sheet. In my case .05" and the parts with tenon cuts as a flip are not lining up with the outline cutter by that amount. I haven't test on my end yet but thought that it may be known already. I'm going to run a test with a larger trim amount and see if it affects it.
- Brad McIntosh
- Guru Member
- Posts: 507
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Location: St. Zotique, Québec, Canada
Who is online
Users browsing this forum: No registered users and 4 guests