Flip ops first problem

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Forrest Chapman
eCabinets Beta Tester
Posts: 1091
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Flip ops first problem

Postby Forrest Chapman » Thu, Nov 19 2015, 2:52PM

I think that control nest is not compensating properly for the amount it trims off the sheet. In my case .05" and the parts with tenon cuts as a flip are not lining up with the outline cutter by that amount. I haven't test on my end yet but thought that it may be known already. I'm going to run a test with a larger trim amount and see if it affects it.

Forrest

User avatar
Brad McIntosh
Guru Member
Posts: 482
Joined: Wed, May 18 2005, 6:59PM
Company Name: CNC Automation
Location: St. Zotique, Québec, Canada
Contact:

Re: Flip ops first problem

Postby Brad McIntosh » Fri, Nov 20 2015, 10:34AM

Forrest,

Are we to assume that you are using the latest Control Nesting 5.89?

Forrest Chapman
eCabinets Beta Tester
Posts: 1091
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Re: Flip ops first problem

Postby Forrest Chapman » Fri, Nov 20 2015, 10:37AM

Yes, I will run a test later today.

Forrest


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests