door/draw front deisgner

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

t w fortier
New Member
Posts: 11
Joined: Fri, Dec 04 2015, 1:02PM
Company Name: linus fortier llc
Country: UNITED STATES

door/draw front deisgner

Postby t w fortier » Tue, Dec 08 2015, 8:22PM

in the above designer, I can not edit the 'door name' or 'directory' boxes to save my door.
Is there someplace I am to go first before I got to the door/draw front designer so I can save my doors?

Clint Buechlein
Thermwood Team
Posts: 170
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: door/draw front deisgner

Postby Clint Buechlein » Wed, Dec 09 2015, 9:00AM

When you open the designer, first select either door or drawer at the top. You then select your source whether it be Slab, MDF, etc. Then click the blue text that reads "Standard", and then click one of the standard doors. Make your changes in material, costing, etc (if any) and click save. When the dialog box opens after clicking save, clear the text where it says "Standard" and start typing in a name for the a new directory. Do the same for the name of the door or drawer. Clicking save will save it in the new directory you named with the name you stated.

t w fortier
New Member
Posts: 11
Joined: Fri, Dec 04 2015, 1:02PM
Company Name: linus fortier llc
Country: UNITED STATES

Re: door/draw front deisgner

Postby t w fortier » Wed, Dec 09 2015, 2:00PM

I found where I went wrong...


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 12 guests