in the above designer, I can not edit the 'door name' or 'directory' boxes to save my door.
Is there someplace I am to go first before I got to the door/draw front designer so I can save my doors?
door/draw front deisgner
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 11
- Joined: Fri, Dec 04 2015, 1:02PM
- Company Name: linus fortier llc
- Country: UNITED STATES
-
- Thermwood Team
- Posts: 702
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: door/draw front deisgner
When you open the designer, first select either door or drawer at the top. You then select your source whether it be Slab, MDF, etc. Then click the blue text that reads "Standard", and then click one of the standard doors. Make your changes in material, costing, etc (if any) and click save. When the dialog box opens after clicking save, clear the text where it says "Standard" and start typing in a name for the a new directory. Do the same for the name of the door or drawer. Clicking save will save it in the new directory you named with the name you stated.
-
- New Member
- Posts: 11
- Joined: Fri, Dec 04 2015, 1:02PM
- Company Name: linus fortier llc
- Country: UNITED STATES
Re: door/draw front deisgner
I found where I went wrong...