Sloped vent hood top

[t w fortier]

Hi...
Is there a way to slope the top of a vent hood in ecabinet or door ?
tony

[tim lucas]

Hi...
Is there a way to slope the top of a vent hood in ecabinet or door ?
tony

Is this what you mean?

W3612 Vent Hood.jpg (10.51 KiB) Viewed 3632 times

or

Hood 32.jpg (9.48 KiB) Viewed 3632 times

Tim

[t w fortier]

Tim, Hood 32.jpg is what I mean.
tony

[tim lucas]

Here is the file for it

Hood 32.hsf

(198.02 KiB) Downloaded 163 times

I just used the rotate tool and part editor to create the look of the hood - I did not cut the hood out from this file

Tim

[t w fortier]

Tin thanks for the reply, I down loaded your file and got 4x8 display board, ??
I up loaded my vent hood, it is very crude.
The only way could make it was to use two cabs but I could not find a way to associate the two cabs as one. Can you or someone else improve on the file I uploaded?
tony

6 VENT HOOD 3.esa

(862.02 KiB) Downloaded 156 times

[tim lucas]

Tony

You are correct, you can not save 2 cabinets as 1 but your assembly will work just like a cabinet in your room
As I said I did not cut my hood it was for show only. I looked at yours and if that is what you need then it is just right.
If you are planning to cut it out and build it I might suggest changing the cabinets to frameless and letting your doors cover to the edges.

You are on the right path

Tim