Hi...
Is there a way to slope the top of a vent hood in ecabinet or door ?
tony
Sloped vent hood top
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 11
- Joined: Fri, Dec 04 2015, 1:02PM
- Company Name: linus fortier llc
- Country: UNITED STATES
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Sloped vent hood top
Is this what you mean? or Timt w fortier wrote:Hi...
Is there a way to slope the top of a vent hood in ecabinet or door ?
tony
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- New Member
- Posts: 11
- Joined: Fri, Dec 04 2015, 1:02PM
- Company Name: linus fortier llc
- Country: UNITED STATES
Re: Sloped vent hood top
Tim, Hood 32.jpg is what I mean.
tony
tony
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Sloped vent hood top
Here is the file for it
Tim
I just used the rotate tool and part editor to create the look of the hood - I did not cut the hood out from this fileTim
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- New Member
- Posts: 11
- Joined: Fri, Dec 04 2015, 1:02PM
- Company Name: linus fortier llc
- Country: UNITED STATES
Re: Sloped vent hood top
Tin thanks for the reply, I down loaded your file and got 4x8 display board, ??
I up loaded my vent hood, it is very crude.
The only way could make it was to use two cabs but I could not find a way to associate the two cabs as one. Can you or someone else improve on the file I uploaded?
tony
I up loaded my vent hood, it is very crude.
The only way could make it was to use two cabs but I could not find a way to associate the two cabs as one. Can you or someone else improve on the file I uploaded?
tony
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Sloped vent hood top
Tony
You are correct, you can not save 2 cabinets as 1 but your assembly will work just like a cabinet in your room
As I said I did not cut my hood it was for show only. I looked at yours and if that is what you need then it is just right.
If you are planning to cut it out and build it I might suggest changing the cabinets to frameless and letting your doors cover to the edges.
You are on the right path
Tim
You are correct, you can not save 2 cabinets as 1 but your assembly will work just like a cabinet in your room
As I said I did not cut my hood it was for show only. I looked at yours and if that is what you need then it is just right.
If you are planning to cut it out and build it I might suggest changing the cabinets to frameless and letting your doors cover to the edges.
You are on the right path
Tim
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us