Beaded face Frames

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Chris B Campbell
Junior Member
Posts: 95
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Beaded face Frames

Postby Chris B Campbell » Sun, Jan 31 2016, 12:11PM

Hey All,
We have been doing a few beaded face frames using the Kreg jig. Actually works pretty good. What I would like to do is give the cut out/build sheets to the shop with dimensioned F/F centers, in other words I would like to give the shop the center of two mid rails so there's no mistake in were to cut out the 3/8" deep X 2" notches on the stiles. No math for the shop... Make sense??

Tried going from board stock to sheet stock still will only give me the corners to select for dimensions.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Ralph Balanik and 33 guests