rotating display cube

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Mike Lew
Junior Member
Posts: 26
Joined: Thu, Feb 08 2007, 8:34PM

rotating display cube

Postby Mike Lew » Wed, Feb 03 2016, 12:46PM

I'm trying to put a laminate wall attached to the side of a cabinet. 24 wide 84 tall 4 deep. I'm having trouble rotating into proper position. Do all the adjustments need to happen in the assembly editor? When wall(cube) is associated to cabinet and both are crosshatched, it wont bring the cube with the cabinet to the editor, yet when in room layout they move together and I can't separate them. Also how do we keep items on the floor, creating this cube put 1/2 of it underground. Is there a default to place all items on the floor? Thanks

Mike Lew
Junior Member
Posts: 26
Joined: Thu, Feb 08 2007, 8:34PM

Re: rotating display cube

Postby Mike Lew » Wed, Feb 03 2016, 1:04PM

I was able to separate in custom layout. When display cube is crosshatched, it not move to assembly/part editor. Other cabinets will.

Mike Lew
Junior Member
Posts: 26
Joined: Thu, Feb 08 2007, 8:34PM

Re: rotating display cube

Postby Mike Lew » Wed, Feb 03 2016, 1:27PM

Another item I'm struggling with is the way items get loaded onto the xyz point and having to move them into correct position. Is there a way to disable that feature? Just want to load a cabinet or panel or cube and snap into position.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Google [Bot] and 8 guests