parts nested

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Mike Lew
Junior Member
Posts: 26
Joined: Thu, Feb 08 2007, 8:34PM

parts nested

Postby Mike Lew » Mon, Feb 15 2016, 12:28PM

I like to make my top stretchers out of different material than carcass. I would like them to show up in the cutting list, but not in the nesting. I thought there was a way to do this. Any ideas? Thanks, Mike

Rob Davis
Guru Member
Posts: 316
Joined: Mon, May 23 2005, 5:43PM
Location: Indiana
Contact:

Re: parts nested

Postby Rob Davis » Mon, Feb 15 2016, 12:45PM

On the nesting page, go to "Filter" and take them out by clicking in box. Then re-nest the job.

Mike Lew
Junior Member
Posts: 26
Joined: Thu, Feb 08 2007, 8:34PM

Re: parts nested

Postby Mike Lew » Mon, Feb 15 2016, 4:22PM

Thanks Rob, I wasn't opening the tree far enough.

Mark McCallum
Senior Member
Posts: 229
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: parts nested

Postby Mark McCallum » Tue, Feb 16 2016, 7:45AM

Hi Mike
A variation we use that may fit in with your system.
We have created a material 19mm x40 rail, and in construction setting for top material choose it, then set the front and back rails to 40mm.
As long as you have your saw blade Kerf under setting preferences/ standard settings as 3mm or what ever, it wont nest the material. (if you make the material 46mm or bigger it will)
It saves turning the tree setting off and comes up with a list saying "Warning the following parts cant be nested"
Click on the file button on top and you can print out a simple list for cutting the left right stretchers on the saw.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Bing [Bot] and 4 guests