I was wondering if there are aggregates shown on the Thermwood site as I cant see any listed. I have a MTR model so I would like to know what is available for my model. I was hoping for a saw that will cut at a 45 and 135 degree angle in the X and Y axis if there is such a thing. Only need to cut 7mm deep. If any user is doing this already would be interested on its good and bad points.
Discuss Thermwood 3-axis Machinery, Controller, and Software.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests