Last line feed speed
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 98
- Joined: Thu, Jun 30 2005, 10:04PM
Last line feed speed
Howdy,
I'm using 4.86. I have Last line feed speed set to 300. Outline tool feed speed is 800. I've been getting a lot of parts with the last line feed speed of 800. Anyone else seeing this?
Dave
I'm using 4.86. I have Last line feed speed set to 300. Outline tool feed speed is 800. I've been getting a lot of parts with the last line feed speed of 800. Anyone else seeing this?
Dave
-
- Junior Member
- Posts: 98
- Joined: Thu, Jun 30 2005, 10:04PM
Dave,
Try updating to the latest version 4.87 and see if you are still seeing the issue. I had posted a program through 4.87 and it looked good. If you still see the issue, please sent me the file that you are nesting along with the following files from your machine:
C:\\RollingNest\\machine.ini
C:\\RollingNest\\tools.thm
C:\\system\\toolman.thm
Try updating to the latest version 4.87 and see if you are still seeing the issue. I had posted a program through 4.87 and it looked good. If you still see the issue, please sent me the file that you are nesting along with the following files from your machine:
C:\\RollingNest\\machine.ini
C:\\RollingNest\\tools.thm
C:\\system\\toolman.thm
-
- Junior Member
- Posts: 98
- Joined: Thu, Jun 30 2005, 10:04PM
Hi Dave,
I've tried to reproduce the situation that you are explaining, but have been unable to do so. The only thing that I might add, I've been testing in V4.91, this may be the difference. If you still see the issue after updating to v4.91, I would like to see the following files:
- .hsf (cabinet file) or .esa (Assembly file)
- .twd file that you are using from ecab
- .cnc file that you've generated at CNC machine
- C:\\RollingNest\\machine.ini (From Thermwood Controller)
- C:\\RollingNest\\tools.thm (From Thermwood Controller)
- C:\\System\\Toolman.thm (From Thermwood Controller)
I've tried to reproduce the situation that you are explaining, but have been unable to do so. The only thing that I might add, I've been testing in V4.91, this may be the difference. If you still see the issue after updating to v4.91, I would like to see the following files:
- .hsf (cabinet file) or .esa (Assembly file)
- .twd file that you are using from ecab
- .cnc file that you've generated at CNC machine
- C:\\RollingNest\\machine.ini (From Thermwood Controller)
- C:\\RollingNest\\tools.thm (From Thermwood Controller)
- C:\\System\\Toolman.thm (From Thermwood Controller)