I had a quick dig around and couldn't find anything.
So I thought I'd ask the collective Ecabs mind.
Once you create a set in the Constraints Manager, can you uncreate it to re-edit? I was trying to change diameters and don't think I can ungroup it?
Also can you copy and paste sets within the CM, I tried a few ways but I don't think so. Just looking for confirmation?
Any feed back appreciated.
Thanks
Mark
Sets in Constraints editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 507
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
-
- Thermwood Team
- Posts: 696
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Sets in Constraints editor
Mark,
To undo a Set, choose the delete like you would to do a dimension and then select the set icon (the green S with the green circle on it). That will ungroup them from a set, you can make your changes and recreate the set.
-Clint-
To undo a Set, choose the delete like you would to do a dimension and then select the set icon (the green S with the green circle on it). That will ungroup them from a set, you can make your changes and recreate the set.
-Clint-
-
- Guru Member
- Posts: 507
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Re: Sets in Constraints editor
Thanks Clint.
That makes sense.
That makes sense.